Operating Modes

The measuring tool has several operating modes, which you can switch between at any time:

• Cross-line mode (see figures A−C and F): The measuring tool generates a horizontal and a vertical laser line out of the front laser outlet aperture as well as a vertical laser line out of the side laser outlet aperture (1). Both vertical laser lines run at a 90° angle to each other.
• Vertical mode (see figure D): The measuring tool generates a vertical laser line out of the front laser outlet aperture as well as one out of the side laser outlet aperture (1). Both laser lines run at a 90° angle to each other.
• Horizontal mode (see figure E): The measuring tool generates a horizontal laser line out of the front laser outlet aperture (1).

After switching on, the measuring tool is in cross-line operating mode. To change the operating mode, press the on/off button (3) as often as required until the laser beams are generated in the required operating mode.

All operating modes can be selected with both automatic levelling or the pendulum lock.