Inserting/Changing the batteries
It is recommended that you use alkaline manganese batteries to operate the measuring tool.
To open the battery compartment cover (7), press the locking mechanism (6) and lift open the battery compartment cover. Insert the batteries.
When inserting the batteries, ensure the polarity is correct according to the representation on the inside of the battery compartment cover (7).
If the non-rechargeable batteries are running low, the laser lines will flash slowly for approx. 1 min.
If the non-rechargeable batteries are empty, the status indicator (2) will light up red and the laser lines will flash quickly for approx. 10 s. The measuring tool will then switch itself off.
Always replace all the batteries at the same time. Only use batteries from the same manufacturer and which have the same capacity.
- Take the batteries out of the measuring tool when you are not using it for a prolonged period of time. The batteries can corrode during prolonged storage in the measuring tool.