Changing the Tool

Insert the chuck key (6) into the corresponding hole of the keyed chuck  and turn it in the direction of rotation ➊ until the application tool can be inserted.

Insert the application tool and clamp it evenly by turning the chuck key (6) in the direction of rotation ➋.

You should always use a universal bit holder when using screwdriver bits.

Hold the rear sleeve (11) of the keyless chuck (9) firmly and turn the front sleeve (10) in the rotational direction ➊ until the tool can be inserted. Insert the tool.

Hold the rear sleeve (11) of the keyless chuck (9) and firmly tighten the front sleeve (10) by hand in the rotational direction ➋ until it stops clicking. This will automatically lock the drill chuck.

The lock will disengage again if you turn the front sleeve (10) in the opposite direction to remove the tool.