Slope operation in the horizontal position

When the measuring tool is in a horizontal position, the Y-axis can be tilted in a range of ±15 %.

  1. Press the  button to tilt the laser plane in a Y– direction.
  2. Press the  button to tilt the laser plane in a Y+ direction. 

The value in the slope angle indicator (8) will change more quickly if the button is pressed and held.

The selected slope is implemented on the measuring tool a few seconds after the last press of a button. The slope angle indicator (8) flashes red until the process of setting the slope has been completed. Once the set value has been reached, the slope angle indicator (8) lights up continuously red.

To reset the Y-axis to 0 %, you can also briefly press the and  buttons simultaneously.